- Offizieller Beitrag
:wall:
ZitatAlles anzeigenjor xxxxxxxx system rebuild (this one you need to discover on your own)
1.Aerosoft Lido NavDataPro
2.Can't transfer GPS data to scratch-pad
3.V1 on Speed tape
4.Hud FMA's
5.Wind calculations- Descend page-forecast
6.V2 Speed
7.Efis/Map 45kns speed tape
8.Check if bump mapping of the vertical stab now works for all FSX models
9.Refueling rate too high
If you open the valves of the three tanks at the same time, each tank will only get 300kg/min each.
If you open only one valve, the related tank will get the full 900kg/min.
10.Inaccuracy of the step functionality of the CDU legs page with the ND in PLAN mode.
11.SID drawing issues
12.Aircraft elevator and trim out with turbulence at cruise altitude.
13.E/D conditions not always met.
14.TCAS not displaying all traffic on some FS9 systems.
15.VOR Course not being drawn when selected using hardware radio's
16.N1 light on MCP not illuminating at thrust reduction altitude on climb out.
17.When runway selected on route page it does not filter sids
18.IAN should only engage if a procedure was selected from the FMC, VOR,
NDB, RNAV, ILS with no G/S (add easy and realistic modes)19.There should be NO SPACE between GS+speed and TAS+speed at ND
20.selected SID and RWY,after EXEC, the RWY did not become ACT
21.If there are 2 way-points with the same ID in LEGS page, then CDU will fail to delete the first one using LSK.
22.VNAV approach speeds
23.VNAV Profile (no weather)
24.SID/STAR Approach section, alphabetic and chronological
25.No ambient sound with ISFD gauge
26.Way-point Stepping
27.ILS display problem on PFD
28.SIMU page > PANEL STYLE > AUTOPILOT page 4/4 > IAN MODE >
the two options are blank/not displayed on the left side, only SEL
shown on right side of the CDU page.29.SID page not reverting to page 1 after choosing runway
30.FMC APPR REF page
Clicking on the LSK next to WIND CORR should transfer the actual value to the scratch-pad.
31.FMC intercept heading'-logic problem
32.switching from VNAV too LVL CHG during descend
33.Sync Baro settings (CAPT/FO easy mode)
34.Unable to delete a way-point in the Route page.
35.vor/loc and app activating simultaneous
36.VNAV flaps speed
37.TAI ON ABOVE 10'C and wing&engine anti-ice switches
38.CWS logic error
39.Baro STD font & MAG HDG size
40.HUD artifact
41.Add HOLD leg distance/time
42.Range indications missing in CTR mode
43. OVHD EFIS switch logic